M&C GENTWO PMA1000 Instruction Manual page 44

Channel Parameter description
Selection: 2= Hardware configuration
K1 mA range 1=0-20 mA, 2=4-20 mA
K1 Gas flow from Kx (1...n)
K1 pressure reading on screen Kx (1...n) enable=0, disable=1
K1 flow reading on screen Kx (1...n) enable=0, disable=1
K1 Option negative reading ignore: 0=no, 1=yes, active
K1 Option pressure compensation: 0=no, 1=P_In, 2=P_Out
Selection: 3= Calibration
K1 zero gas [vol%]
K1 span gas [vol%]
K1 Holding time [s] of relay 2 after calibration
K1 Calibration: MIN range zero gas [vol%]
K1 Calibration: MAX range zero gas [vol%]
K1 Calibration: MIN range span gas [vol%]
K1 Calibration: MAX range span gas [vol%]
K1 Calibration: MeasRange for zero gas
K1 Calibration: MeasRange for span gas
K1 AutoCal: zero gas [vol%]
K1 AutoCal: span gas [vol%]
K1 AutoCal: MIN range zero gas [vol%]
K1 AutoCal: MAX range zero gas [vol%]
K1 AutoCal: MIN range span gas [vol%]
K1 AutoCal: MAX range span gas [vol%]
K1 AutoCal: MeasRange for zero gas
K1 AutoCal: MeasRange for span gas
Selection: 4= Measuring range selection
K1 measuring range at start
K1 measuring range 2 from [vol%]
K1 measuring range 2 to [vol%]
K1 measuring range 3 from [vol%]
K1 measuring range 3 to [vol%]
Selection: 5= Thresholds (Lim)
K1 range op. lim 1 lim2 +- [vol%]
Selection: 6= Sensor assignment
K1 Assignment sensor module values (No. 1-3)
K1 ..IR bench OUT3A-HSSW output for active Kxn (0=not active)
K1 ..IR bench A8-OUT Meas. ch2 for active Kxn (0=not active)
K1 ..IR bench A8-OUT Meas. ch3 for active Kxn (0=not active)
43
PMA1000/PMA1000L | 1.00.00
Default
value
2
1
0
0
0
0
0.000
20.960
1
-2.000
2.000
19.000
24.000
1
4
0.000
20.960
-2.000
2.000
19.000
24.000
1
3
3
0.000
10.000
0.000
30.000
0.000
1
0
0
0
www.mc-techgroup.com