Fig. 36: Highlighted Scroll Bar To Set Operating Parameter Lim1; Fig. 37: Highlighted Scroll Bar To Set Operating Parameter Lim2 - M&C GENTWO PMA1000 Instruction Manual

To change the value of Lim1, please tap on the edit button to the right of operating pa-
rameter 'Lim1'. A scroll bar will open, where you can select numbers before and after the
decimal point. The selected value needs to be displayed in the gray frame in the middle of
the operating parameter scroll bar. Please tap on the green check mark to confirm your
selection.

Fig. 36: Highlighted scroll bar to set operating parameter Lim1

1
Selected value for Lim1
3
Indicators for operating parameter
Lim1 and Lim2
To select operating parameter Lim2, please follow the same steps as for Lim1.

Fig. 37: Highlighted scroll bar to set operating parameter Lim2

1
Selected value for Lim2
3
Indicators for operating parameter
Lim1 and Lim2
To define operating parameter values and change the calculation method behind the
values, please refer to chapter ' M4/S2 - Settings menu/ parameters'.
PMA1000/PMA1000L | 1.00.00
2
Active edit button changes into a check mark
4
Current operating parameter values
Lim1 and Lim2 (setting not activated by default)
2
Active edit button changes into a check mark
www.mc-techgroup.com
1
2
3
4
1
2
3
38