Personal Protective Equipment; For Your Own Safety During Operation; Switching-Off And Securing The Drilling-Milling Machine - Optimum OPTImill MB 4PV Operating Manual

1.11

Personal protective equipment

For certain work personal protective equipment is required.
Protect your face and your eyes: Wear a safety helmet with facial protection when performing
works where your face and eyes are exposed to hazards.
Use protective gloves when handling pieces with sharp edges.
Wear safety shoes when you assemble, disassemble or transport heavy components.
Use ear protection if the noise level (emission) in the workplace exceeds 80 dB (A).
Before starting work make sure that the required personnel protective equipment is available at
the work place.
CAUTION!
Dirty or contaminated personnel protective equipment can cause illness. It must be
cleaned after each use and at least once a week.
1.12

For your own safety during operation

WARNING!
Before activating the drilling-milling machine ensure that this will neither endanger other
persons nor cause damage to equipment.
Avoid any unsafe work methods:
Make sure that nobody is endangered by your work.
The instructions mentioned in these operating instructions have to be strictly observed

during assembly, operation, maintenance and repair.
Use protective glasses!

Switch off the drilling-milling machine before measuring the workpiece.

Do not work on the drilling-milling machine, if your concentration is reduced, for example,

because you are taking medication.
Stay on the drilling-milling machine until the working spindle has come to a complete

standstill.
Use the prescribed personnel protective equipment. Make sure to wear a well-fitting work

suit and, if necessary, a hairnet.
Do not use protective gloves when drilling or milling.

Disconnect the shock-proof plug from the outlet before replacing the tool.

Use appropriate auxiliary materials to remove drilling and milling chips.

Make sure that your work does not endanger anyone.

Safely and firmly clamp the workpiece before switching on the drilling-milling machine.

We specifically point out the dangers when describing the work with and on the drilling-milling
machine.
1.13

Switching-off and securing the drilling-milling machine

Unplug the main switch before starting any maintenance or repair work.
Secure the main switch on the MB4PV with a padlock to prevent it from being switched on
accidentally.
Version 1.1.8 - 2021-7-29 Translation of original instructions
MB4P ǀ MB4PV EN
75