Personal Protective Equipment; Safety During Operation - Optimum Optimill F3 Operating Manual

General check
Equipment
Protective housing
Signs,
Markers
Sight window
Date:
Functional check
Equipment
EMERGENCY STOP
push button
Switch cabinet cooling
Separating protective
equipment around the
CNC machine
Date:
1.11

Personal protective equipment

For certain work personal protective equipment is required.
Protect your face and your eyes: Wear a safety helmet with facial protection when performing
work where your face and eyes are exposed to hazards.
Wear protective gloves when handling pieces or tools with sharp edges.
Wear safety shoes when you assemble, disassemble or transport heavy components.
Use ear protection if the noise level (emission) in the workplace exceeds 80 dB (A).
Before starting work make sure that the required personnel protective equipment is available at
the work place.
CAUTION!
Dirty or contaminated personnel protective equipment can cause illness. It must be
cleaned after each use and at least once a week.
1.12

Safety during operation

WARNING!
Before activating the CNC machine, ensure that this will not endanger other persons or
cause damage to equipment.
Avoid any unsafe work methods:
The instructions mentioned in these operating instructions have to be strictly observed dur-

ing assembly, operation, maintenance and repair.
Safety
Version 1.0 dated 2015-05-27
Check
Switching function, firmly bolted and not damaged
Installed and legible
Check for mechanical damage (scratches, cracks).

cracks,, "Polycarbonate windows" on page 14
checked by (signature):
Check
After actuating an EMERGENCY STOP push button the CNC
machine must be switched off.
The cabinet cooling must be running.
If the protective equipment is open it must not be possible to
start program.
checked by (signature):
Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
OK
OK
F3 GB
Page 15