If you experience any problems with the Important Safety Information Warranty in this manual. installation or operation of your unit, Warnings contact your local Roundup Authorized If the unit arrives damaged, contact Specifications Service Agency. the carrier immediately and file a dam- Dimensions –...
IMPORTANT SAFETY WARNINGS The following tips are recom- mended for maintenance of your INFORMATION stainless steel equipment: Be advised of the following warnings when operating and performing mainte- • Always use soft, damp cloth for Use the following guidelines for safe op- nance on this unit.
OPERATION INSTALLATION Turn the unit on and allow it to Remove unit and all packing mate- warm up until USE appears in the rials from shipping carton. display Open the Accessories Box. It should Drop product into the appropriate contain the following: lane on the Bun Feeder according •...
USER MODE Purging buns from Toaster NOTE: The recommended temperature setting for the Rear Platen is 545 If buns get stuck in the toaster, press and F (285 C). User Mode allows an operator to view the hold both the UP and DOWN arrow but- toaster settings but does not permit any Press the PROGRAM button to pro- tons to increase the belt speed until the...
DAILY CLEANING 11. Reinstall the Front and Rear Con- To lock out the front Conveyor veyor Covers and then re-install the Roller, face the front of the toaster. Turn the toaster’s power switch to Bun Feeder. Use both hands and push down on the off position.
Re-engage the Upper Belt Frame Lock by lifting up and then locking it in place on the Front Conveyor Assembly. Close and latch the Side Panel. NOTE: Inform the Store Manager after any Belt Replacement so new Belts can be ordered. To obtain new Belts, contact the factory at 1-877-392-7854 (North America only) or 630-784-1000.
Page 9
THIS PAGE LEFT INTENTIONALLY BLANK P/N 1011189 Rev. B 07/14...
Mileage in excess of 2 hours (100 miles/160 km) round trip from the nearest authorized service agency. 2. Roundup reserves the right to make changes in design or add any improvements on any product. The right is always reserved to modify equipment because of factors beyond our control and government regulations. Changes to update equipment do not constitute a warranty charge.
Need help?
Do you have a question about the GST-5V and is the answer not in the manual?
Questions and answers