Important Safety Information; Warnings - Roundup GST-5V Owner's Manual

IMPORTANT SAFETY
INFORMATION
Use the following guidelines for safe opera-
tion of the unit.
y Read all instructions be-
fore using equipment.
For your safety, the equipment is
y
furnished with a properly grounded
cord connector. Do not attempt to
defeat the grounded connector.
Install or locate the equipment only
y
for its intended use as described in
this manual. Do not use corrosive
chemicals in this equipment.
Do not operate this equipment if
y
it has a damaged cord or plug, if
it is not working properly, or if it
has been damaged or dropped.
This equipment should be serviced
y
by qualified personnel only. Contact
your nearest Authorized Service
Agency for adjustment or repair.
Do not block or cover any
y
openings on the unit.
Do not immerse cord or plug in water.
y
Keep cord away from heated surfaces.
y
Do not allow cord to hang over
y
edge of table or counter.
y Turn the power off, unplug the
power cord, and allow unit to cool
down before performing any service
or maintenance on the unit.
y The equipment should be grounded
according to local electrical codes
to prevent the possibility of electri-
cal shock. It requires a grounded
receptacle with separate electrical
lines, protected by fuses or circuit
breaker of the proper rating.
All electrical connections must be in
y
accordance with local electrical codes
and any other applicable codes.
Do not clean this appli-
y
ance with a water jet.
This appliance is not to be used by
y
persons (including children) with
reduced physical, sensory, or mental
capabilities, or lack of experience and
knowledge unless they have been
given supervision or instructions.
Do not allow children to
y
play with the appliance.
P/N 1011263 Rev. C 12/15

WARNINGS

Be advised of the following warnings when
operating and performing maintenance on
this unit.
If the supply cord is damaged, it must
y
be replaced by the manufacturer or
its service agent or a similarly quali-
fied person in order to avoid a hazard.
y Do not modify the power sup-
ply cord plug. if it does not fit the
outlet, have a proper outlet in-
stalled by a qualified electrician.
y Do not use an extension
cord with this appliance.
Electrical ground is re-
y
quired on this appliance.
Check with a qualified electri-
y
cian if you are unsure if the ap-
pliance is properly grounded.
If a chemical cleaner is used, be
y
sure it is safe to use on cast alu-
minum. Observe all precautions
and warnings on product label.
Inspection, testing, and repair
y
of electrical equipment should
only be performed by quali-
fied service personnel.
This equipment is to be installed to
y
comply with the basic plumbing code
of the Building Officials and Code
Administrators, Inc. (BOCA) and the
Food Service Sanitation Manual of the
Food and Drug Administration (FDA).
To ensure proper steaming character-
y
istics, some calcium/mineral deposits
must be present on the genera-
tor surface. If, during cleaning, the
surface does become free of calcium/
mineral deposits, add plain tap water
to the surface and allow it to boil off.
This may have to be repeated several
times to ensure proper steaming
characteristics by creating a thin
layer of deposits on the surface.
Do not use a sanitizing solu-
y
tion or abrasive materials. The
use of these may cause damage
to the stainless steel finish.
Chlorides or phosphates in clean-
y
ing agents (e.g. bleach, sanitizers,
degreasers or detergents) could cause
permanent damage to stainless steel
equipment. The damage is usually in
the form of discoloration, dulling of
metal surface finish, pits, voids, holes,
or cracks. This damage is permanent
and not covered by warranty.
3
y The following tips are recom-
mended for maintenance of your
stainless steel equipment:
Always use soft, damp cloth for
y
cleaning, rinse with clear water and
wipe dry. When required, always rub
in direction of metal polish lines.
Routine cleaning should be
y
done daily with soap, ammo-
nia detergent, and water.
Stains and spots should be sponged
y
using a vinegar solution.
Finger marks and smears should be
y
rubbed off using soap and water.
y Hard water spots should be re-
moved using a vinegar solution.