Configuring The Device - Siemens SIMATIC NET RUGGEDCOM RSG910C Installation Manual
Hide thumbs
Also See for SIMATIC NET RUGGEDCOM RSG910C:
- Installation manual (48 pages) ,
- Installation manual (54 pages)
Table of Contents
Advertisement
Device Management
3.2 Configuring the Device
Ethernet Ports
Connect any of the available Ethernet ports on the device to a management
switch and access the RUGGEDCOM RSG910C console and Web interfaces via the
device's IP address. The factory default IP address for the RUGGEDCOM RSG910C is
https://192.168.0.1.
For more information about available ports, refer to
21)".
3.2
Configuring the Device
Once the device is installed and connected to the network, it must be configured.
All configuration management is done via the RUGGEDCOM RSG910C interface.
For more information about configuring the device, refer to the "RUGGEDCOM ROS
Configuration Manual" associated with the installed software release.
20
"Communication Ports (Page
RUGGEDCOM RSG910C
Installation Manual, 04/2022, C79000-G8976-1405-11
Advertisement
Table of Contents
Need help?
Do you have a question about the SIMATIC NET RUGGEDCOM RSG910C and is the answer not in the manual?
Questions and answers