Disconnecting And Closing - Emerson Micro Motion 3711 Configuration And Use Manual

Getting Started
Removing the termination board cover in hazardous environments could
result in personal injury or property damage.
Any procedure that requires removal of the enclosure end caps must be performed
only in an area known to be non-hazardous. Performance of these procedures in a
hazardous area could result in personal injury or property damage.
2. Ensure that the COM port on the PC is configured for 8 data bits.
3. Ensure that the Model 3711 is powered up.
4. Click the
Direct Connect
ROCLINK 800 makes connection attempts, beginning with COM port 1 on the PC at baud rates
between 1200 and 19.2K. It works through all COM ports on the PC, at all baud rates, until the
connection attempt succeeds.
When a successful connection is made, ROCLINK 800 displays the Configuration Tree window (see
Figure 2-7). This window displays data from the currently connected Model 3711.
Figure 2-7
2.7.1

Disconnecting and closing

To disconnect from the Model 3711, close the Configuration Tree window by clicking on the
upper right corner of the window (see Figure 2-7), or by clicking
To close ROCLINK 800, either click on the
.
File > Exit
14
icon in the toolbar (see Figure 2-2), or click
Direct Connect
.
Configuration Tree window
CAUTION
Close ROCLINK 800
Disconnect from device
in the upper right corner of the main window, or click
X
Micro Motion
Device >
.
File > Close
®
Model 3711 Gas Flow Computers
in the
X