Using The Volumetric Flow Measurement Configuration Panels; Using The Core Interface Configuration Panels - Emerson Micro Motion 3711 Configuration And Use Manual

Model 3711 Operator Interface
Table 13-1 Rates & Totals parameters continued
Parameter Description
Flow Calculations
Volume Flow The uncorrected volume flow rate, as calculated by the
Rate at Flowing Model 3711.
Conditions
Volume Flow The volume flow rate, as calculated by the Model 3711,
Rate at Base and corrected to reference temperature and pressure.
Conditions
Energy Rate at Energy delivery corresponding to the volume flow rate at
Base Conditions base conditions.
Flow Calculation Frequency of flow calculations, in seconds.
Period
Accumulation Totals
Flow Today Total flow for the current contract period, up to the present
time.
Energy Today Total energy delivery for the current contract period, up to
the present time.
Flow Yesterday Total flow for the most recent complete contract period.
Energy Yesterday Total energy delivery for the most recent complete contract
period.
13.2.2

Using the volumetric flow measurement configuration panels

To view process data using the volumetric flow measurement configuration panels, click
.
Setup
• The Input Defs panel (see Figure 6-1) displays the current values for mass flow rate, flowing
pressure, flowing temperature, flowing density, and base density.
• The Mass Compensation panel (see Figure 6-2) displays the current mass flow rate, both
uncompensated and compensated for pressure, and flowing pressure.
To view the current values, either enable
13.2.3

Using the core interface configuration panels

To view process data using the core interface configuration panels, click
The General panel is shown in Figure 13-2. Parameters on the General panel are listed and defined in
Table 13-2. To view the current values, either enable
Note: The Mass Flow, Density, and Temperature panels also display communications status plus
process data for the associated process variable.
Configuration and Use Manual
or click
Auto Scan Update
or click
Auto Scan
Comments
Should always show 1. If any other
value appears, check system
operation.
Meter >
.
Meter > Core Interface
.
Update
.
151