Closing A Device Configuration File; Downloading A Device Configuration File To The Model 3711 - Emerson Micro Motion 3711 Configuration And Use Manual

Administration
14.10.2

Closing a device configuration file

Closing a device configuration file removes that configuration file from ROCLINK 800 software. It
does not remove the file from the Model 3711. However, if you are connected to a Model 3711 and
you close its device configuration window, you are automatically disconnected.
To close a device configuration file:
1. Select the device configuration file that you want to close, either by clicking on it or by using
the Window menu.
2. Click
14.10.3

Downloading a device configuration file to the Model 3711

To download a device configuration file to the Model 3711:
1. Connect to the Model 3711.
2. Click
3. Click
Figure 14-5 Download Configuration dialog box
4. Check the specific types of configuration data that you want to download. Use the
and
Deselect All
5. Click
6. Click
Note: The configuration data is downloaded to the Model 3711's SRAM. If you want to save it to flash
memory, you must perform that step manually (see Section 14.3).
166
.
File > Close
and specify the file that contains the data to be downloaded.
File > Download
. The Download Configuration dialog box is displayed (see Figure 14-5).
Open
buttons to check or uncheck all categories.
. The progress of the download is displayed on screen.
Download
when the download is complete.
OK
®
Micro Motion Model 3711 Gas Flow Computers
Select All