Pulse Input - Advanced Panel - Emerson Micro Motion 3711 Configuration And Use Manual

Configuring I/O
Table 7-12 Pulse Inputs – General parameters continued
Parameter Description
Scanning • Enabled: Input from the remote device is automatically
processed by the Model 3711.
• Disabled: Input from the remote device is ignored and the
configured EU Value is used in calculations.
Alarming • Enabled: Alarms are generated on point failure, and are
written to the alarm log.
• Disabled: A Point Fail alarm may appear in the Active Alarms
field, but will not be written to the alarm log.
Active Alarms Displays any alarms that are currently active for this point.
7.9.2 Pulse Input – Advanced panel
The Pulse Input – Advanced panel is shown in Figure 7-14. Parameters on this panel are listed and
defined in Table 7-13.
Figure 7-14 Pulse Inputs – Advanced panel
Configuration and Use Manual
Comments
If Alarming is enabled, an alarm is
generated when Scanning is set to
Disabled.
To conserve alarm log space,
enable alarms only when
necessary.
The field at the right of the Active
Alarm field displays the alarm bit
status value (0 to 255).
81