Start / Stop Timers - Enovation Controls MURPHY PowerCore MPC-10 Operation Manual

Software Release:
[Application Version 2.8.10128; Configuration Version 2.8.10457]

Start / Stop Timers

NOTE: When the engine is started using one of the start timers, the timer which
started the engine is the timer which will stop the engine. Other start/stop timers will
be ignored if they happen to overlap from the timer that starts the engine.
This section allows the setting of the timers to start and stop the engine. There are three timers, each
with a Start Day and a Stop Day, a Start Time and a Stop Time. This is based on the internal real-
time clock.
Countdown Timer: the countdown timer will be active upon every auto start up until the time is
changed or disabled. It is used when it is desirable for a machine to run for a specific amount of
time unmonitored and then shut itself off when that time has expired or when a local key stop
occurs. Format of HH:MM:SS
NOTE: The countdown timer is only active when starting in Auto mode. This timer will
not start counting if starting in manual mode and switching to Auto while the engine is
running.
Start / Stop Timer (1-3): each of the three timers contains the ability to select from the following
parameters:
Days of the week are factory set to Off.
Start and stop times are factory set to 12.00.00 AM.
Start Day
Sunday
Monday
Tuesday
Wednesday
Thursday
Friday
Saturday
Daily
Off
Start Time: format of HH:MM:SS
Stop Day:
Sunday
Monday
Tuesday
Wednesday
Thursday
Friday
Saturday
Daily
Off
Stop Time: format of HH:MM:SS
Section 40
2016-04-19
39 00-02-0939