Menu Glossary; System - Enovation Controls MURPHY PowerCore MPC-10 Operation Manual

Software Release:
[Application Version 2.8.10128; Configuration Version 2.8.10457]

Menu Glossary

System

Date/Time: allows the setting of the controller's date and time.
Pressure Units: allows the selection of psi, kPa or BAR for pressure designation. Factory set to
PSI.
Temperature Units: allows the selection of Fahrenheit or Celsius for temperature designation.
Factory set to Fahrenheit.
Level Units: allows the selection of Feet or Meters for Level designation. Factory set to Feet.
Flow Units: allows the selection of gal/min (US), gal/min (UK) and lpm (Liters Per Minute) for flow
designation. Factory set to gal/min (US).
Language: select desired language: English, French, German, Spanish, Italian. Factory set to
English.
Brightness: allows the backlight of the screen to be adjusted. Factory set to 90.
Backlight Control: turns off (disables) or on (enables) the screen's backlight. Factory set to Enable.
Standby Timer: setting this timer (HH:MM:SS) allows the screen the designated amount of time
before the controller goes into Standby mode. Factory set to 00:30:00.
Service Reminders: when the service reminder is set to 0, the alarms will be disabled; however, the
countdown will continue and will show the numbers as (-) numbers as it counts down past 0 for
the following parameters: All service reminders factory set to 250 Hrs, with the exception of
Overhaul Life (factory set to 500 Hrs.)
Oil Life
Oil Filter Life
Belt Life
Battery Life
Fuel Filter Life
Air Filter Life
Overhaul Life
Reset All
Stored Fault Codes: allows the operator to query the Engine ECU for review of its stored fault codes.
Auto / Manual: allows the controller to be placed in Manual Mode only and power up in either Manual
or Auto Mode of operation depending on the selection chosen. If the operator enables Manual
Only the choice of power up in auto is hidden. Factory set to Manual.
Green LED: select either Auto Operation or Running Loaded for the built-in green LED.
Restore Factory Defaults: allows the operator to reset all settings back to default.
Section 40
2016-04-19
26 00-02-0939