Start/Stop Settings; Single Contact Start/Stop; Two Contact Maintained Start/Stop (Commonly Known As Floats); Pressure, Temperature Transducer Start/Stop - Enovation Controls MURPHY PowerCore MPC-10 Operation Manual

Software Release:
[Application Version 2.8.10128; Configuration Version 2.8.10457]
Communication
The Communications menu allows the operator to choose the type of RS485 communications such
as PVA Gauge, Modbus or Local Display. The menu also allows for the operator to choose the RS485
slave address and RS485 Serial setup. Review Communication under the Menu Glossary section of
this manual for a full list and definition of each setting.

Start/Stop Settings

There are five automatic start/stop types in the MPC-10 / TEC-10. Each is detailed below:

Single Contact Start/Stop

The Single Contact Start/Stop is when a remote contact closes and remains closed for auto start and
reopens for auto stop.

Two Contact Maintained Start/Stop (commonly known as Floats)

The Two Contact Maintained Start/Stop is when both contacts close for auto start and both contacts
open for auto stop (not momentarily).

Pressure, Temperature Transducer Start/Stop

A transducer can be used for Auto Start/Stop when needed for the application. There are set points that
allow the operator to enter the appropriate values.
NOTES:
This same transducer can be used for Auto Start/Stop and Auto Throttling if the
application supports transducer control.
Discharge pressure is the only pressure type available for Auto Start/Stop and/or Auto
Throttle control by pressure.

Local Start Key Start/Stop:

The Local Start Key function uses the green and red buttons on the front interface for auto start and
stop.

Quick-Start Setup

The following sections provide a walk-through of the steps necessary for some of the various
configurations and settings available on the MPC-10 / TEC-10 Controller. Cycling power to the
controller is recommended after making changes to set points.
Stepping through the Menu will be depicted as follows:
Menu/System/Contrast directs the operator to go into the Menu first, then look for a parameter titled
System and press [Enter] to go into the System menu. Then look for a parameter titled Contrast and
press [Enter] to go into the Contrast menu, etc.
Section 40
2016-04-19
16 00-02-0939