Enovation Controls MURPHY PowerCore MPC-10 Operation Manual page 15

Software Release:
[Application Version 2.8.10128; Configuration Version 2.8.10457]
Chipper
The Chipper application houses the auto start functions and engage/disengage methods
meant to be used on Chippers. The operator can also choose between Chipper types, On-
Off-On or Dumping.
The functions available are:
Auto Start/Stop Functions
• Single Contact (will require a digital input for start and stop)
• Local Start Key
Engage RPM
Disengage RPM
Disengage Delay
Chipper Feed System
• On-Off-On
Dumping
•
Start / Stop Timers
The Start/Stop Timers menu provides the operator the ability to add a countdown timer and start/stop
times. The countdown timer allows for the operator to set a desired countdown time and walk away
from the engine for a controlled shutdown when the timer expires. There are three Start/Stop Timers
the operator can choose from within this menu that allows for the specific day and hour the controller
will start and stop utilizing the internal clock. Review Start/Stop Timers under Menu Glossary section
of this manual for full list and definition of each setting.
NOTE: Start / Stop timers work in conjunction with other Start / Stop types. If the
engine is already running from another Start / Stop type when a Start / Stop timer
occurs, the Start / Stop timer is ignored. Once the engine is started by the Start /
Stop timer, the timer must expire for a controlled shutdown to occur.
Section 40
2016-04-19
Figure 6: Main Menu page 3
15 00-02-0939