Setting To Auto Start On Local Start Key; Setting To Auto Start On Float Inputs; Setting To Auto Start On Pressure; Setting To Auto Start On Clock - Enovation Controls MURPHY PowerCore MPC-10 Operation Manual

Software Release:
[Application Version 2.8.10128; Configuration Version 2.8.10457]

Setting to Auto Start on Local Start Key

1. Access Menu/Application Configuration/Auto Start_Stop Function/Local Start Key and
press [Enter] (not available for Frost Protection).
2. Press the [Menu] key to leave the Menu Setup screens.

Setting to Auto Start on Float Inputs

1. Access Menu/Application Configuration/Auto Start_Stop Function (only available in
Pump All Purpose).
2. Highlight Single Contact or Two Contact Maintained and press [Enter].
3. Press [Back] once and access Input/Output/Digital Inputs. Select a Digital Input to modify.
4. Assign the appropriate input for the selected DI.
NOTE: If Single Contact is chosen, only one digital input needs to be configured. If
Two Contact (Maintained) is chosen, two digital inputs need to be configured - one
for start and one for stop.
5. Ensure the appropriate number of Digital Inputs is configured (as per the Note above), and press
the [Menu] key to leave Setup.

Setting to Auto Start on Pressure

1. Access Menu/Application Configuration/Auto Start_Stop Function/Pressure Transducer,
and press [Enter] (only available in Air Compressor).
2. Complete the parameters that apply (i.e., Maintain Pressure, Start/Stop Pressure, etc.)
3. Press [Back] twice, and access Input_Output/Analog Inputs.
4. Select an Analog Input to modify.
5. Assign the appropriate pressure input for the selected AI.
6. Configure Sensor in the Sensor setup menu.
7. Press the [Menu] key to leave Setup.

Setting to Auto Start on Clock

NOTES:
1) Ensure the correct date and time are established in the System menu prior to
establishing the Auto Start on Clock settings.
2) The MPC-10 / TEC-10 have the ability to establish three different Start/Stop
dates and times. If desired, repeat steps 2-4 for subsequent Timers.
3) The Countdown Timer is separate from the internal clock. This is a run time after
a Key Start is initiated. When this timer expires, an auto stop will occur.
4) The Clock start timer that started the engine is the only timer that stops the
engine.
1. Access Menu/Start_Stop Timers, and select the first Start/Stop Timer.
2. Select Start Day 1 and then select the appropriate day or Daily.
3. Select Start Time 1 and establish the hour, minute and second to start.
4. Establish the Stop Day and Time as in steps 2-3.
Section 40
2016-04-19
18 00-02-0939