Enovation Controls MURPHY PowerCore MPC-10 Operation Manual page 37

Software Release:
[Application Version 2.8.10128; Configuration Version 2.8.10457]
10. The Disengage output turns on.
11. The display will read Feed Reverse.
12. For Feed Off, the operator presses and holds the Enter button for 5 seconds.
13. If on, the Engage output turns off.
14. If on, the Disengage output turns off.
15. The display will read Feed Off.
16. To exit the Autofeed Override feature, press and hold the Back button for 5
seconds. This will return the controller to the main menu. Press the menu button to
return to the front display.
Chipper type: DUMPING:
CHIPPER AUTO MODE
1. (2) Control outputs, Engage and Disengage are off prior to start up.
2. The engine is started manually using the MPC-10 / TEC-10 and throttled manually
up to the Engage RPM set point:
3. The Engage output turns on.
4. If during normal operation, the engine speed drops to the Disengage RPM set
point:
a.
b.
c.
5. When the Disengage delay expires:
a.
b.
6. When the engine speed rises to the Engage RPM set point:
a.
CHIPPER MANUAL MODE (AUTOFEED OVERRIDE)
1. The engine speed must be below the Disengage RPM set point to use the
Autofeed Override feature. An RPMs TOO HIGH warning will appear if the
Autofeed Override menu is accessed while the engine speed is higher than the
Disengage RPM set point.
2. The operator enters the password to access the main menu.
3. Once in the main menu, the operator holds down the Enter button for 5 seconds.
4. The Autofeed Override menu will appear in the Feed Off mode.
5. For Feed Forward, the operator first presses and holds the Up Arrow, then presses
and holds the Enter button, holding both for 5 seconds:
a.
b.
6. For Feed Reverse, the operator first presses and holds the Down Arrow, then
presses and holds the Enter button, holding both for 5 seconds:
a.
b.
c.
7. For Feed Off, the operator presses and holds the Enter button for 5 seconds:
a.
b.
c.
Section 40
2016-04-19
The Engage output remains on.
The Disengage output turns on.
The Disengage delay begins timing.
The Engage output turns off.
The Disengage output turns off.
The Engage output turns on.
The Engage output turns on.
The display will read Feed Forward.
The Engage output remains on.
The Disengage output turns on.
The display will read Feed Reverse.
The Engage output turns off.
If on, the Disengage output turns off.
The display will read Feed Off.
37 00-02-0939