Input / Output Menu - Enovation Controls MURPHY PowerCore MPC-10 Operation Manual

Software Release:
[Application Version 2.8.10128; Configuration Version 2.8.10457]
Throttle Inc/Dec Pulse Delay: format of # mS. The amount of delay time before pulsing the throttle.
Increase this value for slower engine response, or decrease this value for faster engine response.
Factory set to 250mS. (Only appears when Pulse Inc/Dec is chosen)
Throttle Inc Rate: the rate the engine is signaled to increase in RPM. Factory set to 100 RPM/s.
Throttle Dec Rate: the rate the engine is signaled to decrease in RPM. Factory set to 100 RPM/s.

Input / Output Menu

Digital Inputs (1-6): for each of the digital inputs, the ability to select the following parameters exists:
Digital input 1. Factory set to Disabled
Digital Input 2. Factory set to Auto Start Maintained
Digital Input 3. Factory set to Auto Stop Maintained
Digital Input 4. Factory set to Low Coolant Level
Digital Input 5. Factory set to Low Lube Oil Level
Function:
Disabled
Single Contact Start/Stop
Auto Start Maintained
Auto Stop Maintained
Remote Alarm Acknowledge
Low Fuel Level
Fuel Leak
Fuel Filter Restriction
Low Lube Oil Level
Low Coolant Level
Remote Stop
Remote Manual/Auto
Idle Engine
Remote Throttle Inc
Remote Throttle Dec
Water in Fuel
No Flow
User 1
User 2
Active
B- (ground input to a function chosen above) Factory Default
B+ (battery positive to a function chosen above).
Open (sender/switch is open)
Action
Not Used
Warning
Shutdown Factory Default (Depending on Function)
Shutdown, Controlled (will shut down through the normal sequence of operation if a
chosen function listed above occurs)
Relay Control (used to control one of the relay outputs)
Section 40
2016-04-19
33 00-02-0939