Enovation Controls MURPHY PowerCore MPC-10 Operation Manual page 12

Software Release:
[Application Version 2.8.10128; Configuration Version 2.8.10457]
Engine Settings
The Engine Settings menu allows the operator to establish common user-configurable parameters
that would be changed from factory default settings when pairing the controller to an engine. This
menu allows the operator to choose whether the engine is J1939 or mechanical; the engine's speed
source; the minimum and maximum RPM the operator requires/allows the engine to run; warm-
up/cool-down settings; and other common engine settings. Review Engine Settings under the Menu
Glossary section of this manual for a full list and definition of each setting.
Advanced Engine Settings
The Advanced Engine Settings menu allows the operator to set up the less common user-
configurable parameters that are not in the Engine Settings menu and which would be changed from
factory default settings when pairing the controller to an engine. This menu allows the operator to set
items such as the J1939 address claim for the controller, ECU Source Address, ECU hour select,
crank attempts, crank disconnect speed and other user-specific engine settings. Review Advanced
Engine Settings under the Menu Glossary section of this manual for a full list and definition of each
setting.
Figure 5: Main Menu page 2
Throttle
The Throttle menu allows the operator to set up the items for throttling the engine such as throttle
type, rate of RPM increase/decrease, throttle Inc/Dec pulse time and other parameters pertaining to
throttling of the engine. Review Throttle under the Menu Glossary section of this manual for a full list
and definition of each setting.
Input / Output
The Input/Output menu allows the user to establish the I/O needed for the application. This includes
Digital Inputs, Analog Inputs, Relay Outputs and Digital Outputs. This menu is tied to other aspects of
the controller menu such as Auto Start Functions, Analog Inputs for Mechanical Engine setup, Warning
/ Shut-down functions and all outputs needed for starting/controlling the engine and alerting the user.
Section 40 12 00-02-0939
2016-04-19