Enovation Controls MURPHY PowerCore MPC-10 Operation Manual page 34

Software Release:
[Application Version 2.8.10128; Configuration Version 2.8.10457]
Analog Inputs (1-3): for each of the analog inputs, the ability to select the following parameters exists:
Analog input 1. Factory set to Disabled
Analog Input 2. Factory set to Disabled
Analog Input 3. Factory set to Disabled
Function:
Disabled
4-20mA Suction Pressure
0-5V Suction Pressure
4-20mA Discharge Pressure
0-5V Discharge Pressure
4-20mA System Level
4-20mA Flow Rate
4-20mA Ambient Temp
0-5V Ambient Temp
Datcon Oil Pressure
Murphy Oil Pressure
VDO5 Bar Oil Pressure
VDO7 Bar Oil Pressure
Murphy Coolant Temp
Datcon Coolant Temp
VDO Coolant Temp
Murphy Fuel Level
VDO Fuel Level
Datcon Fuel Level
Murphy Oil Temp
Datcon Oil Temp
VDO Oil Temp
Analog.Digital1
0-5V Gearbox Pressure
4-20mA Gearbox Pressure
Murphy PMK-400 Pressure
Sensor Setup (This menu only appears when a transducer [4-20mA or 0-5V] is selected for
an analog input.)
Ambient Temp (0-5V) or (4-20mA)
Discharge Pressure (0-5V) or (4-20mA)
Suction Pressure (0-5V) or (4-20mA)
Flow Rate (4-20mA)
System Level (4-20mA)
Relay (1-3) and Digital (1-4) Outputs: these same parameters are used for both the Relay and Digital
Outputs.
Relay 1. Factory set to Crank, Starter Solenoid
Relay 2. Factory set to ECU Enable
Relay 3. Factory set to Not Used
DO1 (B+, 1A) Factory set to Not Used (Not in Auto)
DO2 (B+, 1A). Factory set to Engine Running
Section 40
2016-04-19
34 00-02-0939