Mounting The M-126 Onto A Surface - PI M-126 User Manual

5 Installation
5.3

Mounting the M-126 onto a Surface

Figure 4: Mounting plate on the bottom of the M-126
There is a mounting plate with two threaded holes (mounting holes) on the bottom of the M-
126. The M-126 is mounted on and underlying surface via this plate. Mounting is from above.
Access to the mounting holes is via two through-holes in the M-126's platform.
Requirements
 You have read and understood the general notes on installation (p. 17).
 You have provided a suitable underlying surface (see "Dimensions" (p. 36) for the
required position of the holes for the screws):
−
−
In addition, for models with electric drive:
 If necessary, the motor housing and connectors of the M-126 were brought into a
suitable position (p. 18) for your application.
 You have accounted for the space required to route cables without bending and
according to regulations.
Tools and Accessories
2 M4 socket head screws, included in the scope of delivery (p. 10)

Hex key, AF 3, included in the scope of delivery

M-126 Precision Microtranslation Stage
Two M4 threaded holes with sufficient depth are provided
Models with electric drive: Depth at least 18 mm

Model with manual drive: Depth at least 20 mm

For applications with large temperature fluctuations: The surface should have the
same thermal expansion properties as the M-126 (e.g., underlying surface made of
aluminum).
MP42E Version: 3.0.0 19