Turning The Connectors Of The M-126 - PI M-126 User Manual

5 Installation
In addition, the following applies for models with electric drive:
NOTICE
Damage if the wrong controller is connected!
Connecting a M-126 to an unsuitable controller can damage the M-126 or controller.
 Connect a M-126 with DC motor to a DC motor controller only.
 Connect a M-126 with stepper motor to a stepper motor controller only.
 If you are using controllers and software from other manufacturers, check their technical
data to make sure that they are suitable before starting and operating the M-126.
The base body (with platform) and motor (with connectors) move together when the M-126 is
operating. Make sure that the M-126 has enough room to move and the connecting cables are
long enough. If necessary, turn the connectors of the M-126 to a position suitable for your
application.
5.2

Turning the Connectors of the M-126

Requirements
 You have read and understood the general notes on installation (p. 17).
Tools and Accessories
Hex key, AF 3 included in the scope of delivery (p. 10)

Turning the connectors of the M-126
1. Use the hex key to loosen the two socket head screws that fix the motor housing.
2. Turn the motor housing with the connections by hand to the desired orientation.
3. Tighten both socket head screws to fix the motor housing completely.
4. Check that the motor housing is sitting firmly on the M-126.
18 Version: 3.0.0 MP42E M-126 Precision Microtranslation Stage