Replacing The Power Supply - HP Visualize B1000 Supplementary Manual

Figure 2-8. Tipping Up the Power Supply
Spring Hinge
Bail
Lock
Bail
5. Disconnect the four cables shown below: three system power cables and the SCA hard
disk backplane cable.
Figure 2-9. Location of Power Cables
6. Remove the power supply from the workstation:
a. Holding the power supply handle, remove the bail from the bail lock.
b. Slide the spring hinge lever toward the front of the workstation and rotate it
downward to lock it in place.
c. Slide the power supply toward the back of the workstation to disengage it from the
right hinge pin, remove the power supply and set it aside.

Replacing the Power Supply

1. To install the power supply:
Chapter 2
Power Cables
Parts Removal and Replacement
Power Supply
Right-side Hinge Pin
17