Parts Removal and Replacement
Power Supply
a. Pick up the power supply by the handle and position its right-side hinge pin into the
right side hinge bracket, as shown below.
b. Align the shaft of the spring hinge (on the left side) with its hole in the hinge
bracket, release the spring-hinge lever, and let it snap left into the hole.
Figure 2-10. Reinstalling the Power Supply
Spring Hinge
Bail
Lock
Bail
2. Connect the four power cables.
• Three system power cables
• SCA hard-disk backplane power cable
Figure 2-11. Location of Power Cables
3. Lift the handle edge of the power supply enough to allow the bail lock to be disengaged
from the bail, fold the bail lock down, and the lower the power supply back into place.
4. Alternately tighten the two captive T-15 Torx screws in the corners of the power supply.
18
Power Cables
Right-side Hinge Pin
Chapter 2