Replacing The Hard Disk Drives - HP Visualize B1000 Supplementary Manual

Parts Removal and Replacement
Hard Disk Drive
CAUTION A drop of just a few inches onto a hard surface such as a desk or the floor can
generate large accelerations (hundreds of G's), which may damage the device.
2. Refer to the hard disk drive you just removed from the workstation. Remove the four screws
securing the drive to the tray, and pull the drive straight up out of the tray.
Figure 2-30. Installing a Hard Disk Drive into its Tray
3. Insert these four screws through the rubber grommets and into the corresponding holes
in the disk drive, and tighten them with a T15 Torx driver. There are four rubber
grommets, although only two are visible in the illustration above.
NOTE Do not remove the grommets; if they are removed, the drive would not be held
securely in the tray and may be damaged as a result.
Once the disk drive is installed into the drive tray, the assembly can be inserted into the
desired hard-drive slot.

Replacing the Hard Disk Drives

1. Facing the front of the workstation, insert the hard disk drive trays halfway into its
appropriate slot. The release lever should be angled away from the front of the drive
tray, as shown below (if it is not, push up on the release hook if necessary, and tip the
release lever out).
34
Screw-storage tab
Release lever
Grommets (do not remove)
Screw-storage tab
Release hook
Chapter 2