Hard Disk Drive; Removing The Hard Disk Drives; Putting A Disk Drive Into Its Tray - HP Visualize B1000 Supplementary Manual

Hard Disk Drive

This section describes how to remove and replace the hard disk drive.
NOTE Prior to removing the Hard Disk Drive, the Front Panel needs to be removed.
See the appropriate section(s) for the steps to remove and replace this
component.

Removing the Hard Disk Drives

1. With your thumb, press upward on the release hook of each hard disk drive, while
pulling down and out with your index finger on the top end of the release lever. As you
pull outward on the release lever, the disk drive tray will easily slide out of the slot.
Figure 2-29. Hard Disk Drive Removal

Putting a Disk Drive into its Tray

When you receive and unpack a new disk drive, it will not include the tray that is needed
in order to insert it into your workstation. These trays are already in the disk-drive bays.
You will need to assemble the disk drive into its tray before you can slide the disk drive
and tray assembly into the workstation.
1. Unpack the new disk drive. Never let it drop onto the floor or onto a desk—always set it
down gently—and observe ESD (electrostatic discharge) precautions, as described in
the Preface of this document.
Chapter 2
Release Hook
Release Lever
Hinge Hooks
Parts Removal and Replacement
Hard Disk Drive
33