Advertisement
OPERATION
Controller
Temperature display
Heater button
Bubble button
16
Up button
Temperature display
Once the spa is turned on, press RESET on the PRCD. The display
will show the current water temperature.
Heating
Press the HEATER button to turn the heating system on/off.
• If the light on the heater button is red, the heating system is
activated. If the light on the heating button is green, the water is at
the set temperature and the heating system is at rest, keeping the
water at the desired temperature.
IMPORTANT: The following conditions will lead to slower heating:
• If the ambient temperature is lower than 10°C.
• Outdoor wind speed is above 3.5-5.4m/s.
• When the massage system is activated.
• If the spa is not properly covered with the spa cover.
Note:
When turned on, the spa's filter will automatically run for 15
seconds to test the heater's functionality. This is normal. In
standard use, the heater will then heat the water towards the
set temperature.
Filter button
Timer button
Down button
Advertisement
