Advertisement
7. Water filling
• Confirm the spa's location and point the drain valve towards a suitable draining area
before filling water.
• Fill the spa tub with fresh water to a level between the minimum and maximum line
marked on the inside of the spa wall. Do not overfill the spa.
Notes:
• If the water level does not fall between the two lines, this may cause a pump
and control system failure.
• Never pour water with a temperature higher than 40°C into the spa directly. It
is recommended to fill the spa tub with lukewarm water to allow the water to
reach an ideal temperature quickly and save electricity and time on heating.
• After the spa is filled, check the spa pool air pressure and ensure the manometer
shows the Green section.
8. Water heating
Refer to the 'Operation' section of this user guide for heating instructions. The maximum
heating temperature is 40°C. The hourly heating rate is around 1.2°C–1.8°C.
14
Maximum
Minimum
Advertisement
