Advertisement
Filtration
Press the FILTER button to turn the filtration function on/off. The light
on the button will turn green when activated.
• The filtration system will automatically start when heating is
activated. It cannot be turned off while the heating system is in
operation.
• After turning off the heating, the filtration system will automatically
stop after 30 seconds. The filtration system can then be activated
separately if desired.
• The auto-filtration system is activated every 4 hours.
Note:
If the light on the FILTER button is flashing red and green
(when the function is on) or flashing red (when the function is
off), the filter cartridge must be cleaned or replaced. Once
cleaned/replaced, press and hold the FILTER button for 3
seconds to reset.
Bubble massage
• Press the BUBBLE button to turn the massage system on/off. The
light on the button will turn green when activated.
• For your safety, the massage system will automatically turn off
after 20 minutes of use. It can be re-activated after 10 minutes.
Note:
The massage system can only be activated when the inflation
knob is in the 'OFF' position.
Adjustment buttons
• Pressing the UP or DOWN buttons will cause the temperature
display to start flashing. Using the UP and DOWN buttons, adjust
the water to the desired temperature setting (from 20°C to 40°C)
within 3 seconds. The new temperature value will remain on the
temperature display to confirm.
• If any other buttons are pressed during the 3 second period,
adjustments to the temperature will be voided.
• Press the UP and DOWN buttons at the same time for 3 seconds
to lock the controller. In the locked mode, all current settings of the
spa are kept. Pressing any buttons in this mode will not change the
settings. To unlock, press the UP and DOWN buttons at the same
time for 3 seconds again.
Note:
The default setting temperature is 38°C.
17
Advertisement
