Advertisement
If the spa inlet or outlet is stuck with dirt, use the wrench to unscrew it and clean the
inlet/outlet.
Notes:
• Never remove the filter cartridge when the spa is filled with water.
• Do not throw away the cartridge base when replacing the filter cartridge. The base
should only be changed when it becomes loose over extended use.
Spa tub cleaning
After the spa water is drained, remove the filter cartridge from the inside of the spa tub wall
and clean/replace the filter cartridge as outlined in the 'Filter cartridge' section of this user
guide. Use a sponge and mild soap solution to wipe away any soil or stains on the inside of
the spa wall. Rinse thoroughly before refilling with clean water.
Notes:
• Do not use steel wool, hard brushes, or abrasive cleaners.
• If the spa will not be for a few days, cover it with the spa cover for protection.
Spa tub repair
Use the enclosed repair kit to repair any puncture by following the steps below:
1. Thoroughly clean and dry the area to be repaired.
2. Apply glue (not included) to the PVC patch and quickly attach it onto the damaged
surface.
3. Smooth the surface to remove any air bubbles and allow it dry for 5–10 minutes.
22
Pin hole
Advertisement
