Advertisement
Site preparation and requirements
• The spa can be installed indoors or outdoors in around 10 minutes. This spa is for
household use only.
• The spa must be set up on a flat, smooth, and supporting surface that can support
the maximum load of the filled spa with the maximum number of occupants.
• Ensure the area is free of sharp objects under or around the spa. Uneven or unsound
surfaces can damage the spa. Level the surface if needed before filling the spa with
water.
• Provide adequate drainage around the spa to deal with the overflowing of water and
splashes.
• Ensure there is enough clearance around the spa for full access to the spa equipment
for maintenance and/or service.
Additional requirements for indoor installation
• Verify the supporting floor can support the filled weight of the spa with the maximum
number of occupants. Check with a qualified contractor or structural engineer to verify
the requirement.
• Ensure the floor is water-resistant and provides a non-slip surface. Do not install the
spa on carpet or any other material that could be damaged by moisture.
• Humidity is a normal side effect when using the spa indoors. Ensure the room where
the spa is installed is properly ventilated to allow moisture to escape. It is strongly
recommended to install a ventilating system to prevent excess condensation moisture
in the room.
Additional requirements for outdoor installation
• Do not set up the spa on grass or dirt as this increases the amount of debris entering
the spa and can cause damage to the spa floor.
• To maximise the life of the spa, do not leave the spa tub exposed to direct sunlight.
• Always keep the manometer in the yellow section when using the spa at a
temperature higher than 20°C, or when it is exposed to sunlight for a short time.
• It is not recommended to install and leave the spa outside at a temperature lower
than 4°C. This ensures the water inside the circulation system, pump, and pipe do not
become frozen. Place a heat preservation mat (not included) between the spa bottom
and the ground to prevent heat loss from the bottom of the spa and to provide better
heat retention.
9
Advertisement
