Table of Contents
Advertisement
OPERATION
5. Water Filling
5.1 Check the spa liner is at the selected area and point the drain valve toward a
suitable draining area before filling water.
5.2 Fill the spa tub with fresh water to a level between Minimum and Maximum line
marked on the inside of the spa wall. Do not over fill the spa. It is recommended to
fill the spa energy saving.
WARNING:
•
Water level must reach the Minimum water line but not exceed the Maximum line to
avoid pump failure.
•
Never pour water with a temperature higher than 40°C into the spa directly.
•
To avoid control system failure, do not operate the spa until water reaches the
Minimum line.
5.3 After water filling, double check the spa pool air pressure to make sure the
manometer points out to the Green section.
5.4 Install the filter cartridge. Please refer to the Maintenance section of this use guide.
5.5 Place the zipper spa cover over the spa tub and make sure the spa cover zipper are
closed and lock the cover by the digital lock in the accessory pack.
IMPORTANT:
•
Inspect the spa air pressure regularly for leak, premature wear or deterioration.
•
Check and wax the zipper regularly, to make it smooth for operation and avoid
splits.
Maximum
Minimum
Advertisement
Table of Contents
