Advertisement
5. Spa inflation
• Plug the spa into a grounded power socket.
• Press 'RESET' on the PRCD and the screen on the controller will display numbers.
• Turn the inflation knob to 'ON' and press and hold the bubble button on the controller
for at least 2 seconds to start inflating.
• Inflate until the yellow section of the manometer is pushed out. Stop pressing the
bubble button and turn the inflation knob to 'OFF'.
ON
Notes:
• Before inflation, check whether the manometer cap is screwed tight on the valve
of spa tub. If not screwed tight, tighten it then inflate. After inflation, the
manometer cannot be removed. Removing the manometer will cause air to
escape.
• The spa will require additional air to be added from time to time. Changes in
temperature from day to night will change the pressure in the spa and may
cause a certain amount of deflation.
Spa deflation
• Unscrew the manometer cap on the spa pool to deflate
the spa.
• Once deflation is complete, place the cap back onto the
spa.
12
Bubble
Yellow
OFF
Advertisement
