Advertisement
PRCD testing
WARNING:
Risk of electric shock: This product is provided with a PRCD located at
the end of the power cord. The PRCD must be tested before each use.
Do not use the spa if the PRCD does not function properly.
Disconnect the power cord until the fault has been identified and corrected. Contact a
licensed electrician to correct the fault.
There are no serviceable parts inside the PRCD.
1. Plug the power cord into a power outlet. Do not use plug boards or faulty sockets.
2. Press the RESET button on the PRCD. The indicator will turn red.
3. Press the TEST button on the PRCD. The red light on the indicator should disappear.
Note:
If the red light does not disappear, the PRCD is faulty. Do not use the spa and contact
a qualified electrician to correct the fault.
4. Press the RESET button on the PRCD again. The indicator should turn red, and the
spa is now ready for use.
✓
Controller connection
A qualified electrician should wire the controller to the household equipotential terminal
using a minimum 1.5mm² solid copper conductor.
10
Indicator
Reset
✗
Test
Advertisement
