Advertisement
INSTALLATION
1. Move the entire package to the selected site. Do not drag the spa tub across the
ground as this can cause damage and future leakage. Open the packaging carefully
as it can be re-used to store the spa during long-term storage or when not in use.
2. Lay out all components on the ground and check all components are located. Ensure
the spa tub is facing the right side up.
3. Spread out the spa tub over the ground and point the drain valve towards a suitable
draining area.
4. Heater resetting
• The heater should be reset when the spa is used for the first time, or after long periods
of storage.
• To reset, find the yellow ring as shown in the picture. Pull it down gently and then
release it.
Note:
The heater cannot work or be reset if the
water temperature or ambient
temperature is higher than 40°C.
11
Advertisement
