Using Hp Maxilife To Diagnose Problems - HP PL Class 450/500/550/600/650/700/750 User Manual

Pre-Boot Checks
Note: Some error
messages displayed
here may not be
available.

Using HP MaxiLife to Diagnose Problems

Your HP LCD can help you to diagnose problems with your HP
V Linux Workstation, even when you are unable to get your
ISUALIZE
system and monitor working properly. Note that the messages in this
section make reference to the "HP Kayak Workstation." For an
explanation of this, see the section "Special Notice for Users" in the
Preface of this document.
When you press your Workstation's on/off button, HP MaxiLife will check
your system before it initiates the start-up sequence. You will see one of
the following screens on the LCD as these checks progress:
Error!
CPU Socket
Check that a CPU or
terminator is installed
in the CPU slots
Error!
Power CPU 2
Check processor 2
VRM installation.
Error!
No RAM
Check memory
installation.
HP KAYAK XA-s
No errors occurred during
pre-boot. POST is
initiated.
Chapter 3
Troubleshooting Your HP Visualize Linux Workstation
Using HP MaxiLife to Diagnose Problems
Error!
Power supply
Check power supply and
power cable
connections.
Error!
Board PLL
Check system board.
Error!
RAM type
Check that RAM types
installed are compatible.
Error!
Power CPU 1
Check processor 1 VRM
installation.
Error!
BIOS
Flash new BIOS.
Error!
No Video
Check that graphics card
is installed correctly.
71