HP PL Class 450/500/550/600/650/700/750 User Manual page 68

Completing the
Installation of a
Processor
NOTE
How to Install Accessories In Your HP Visualize Linux Workstation
Installing a Processor
1. Verify that the system board bus speed switches are correctly
configured for the processor.
If two processors are installed, both must operate at the same bus speed
and processor speed. Refer to the manual supplied with the processor to
verify which bus and processor speeds are supported.
Switch Switch
1 2
1 UP
UP
UP UP
UP UP
UP UP
UP UP
1. UP=OFF, DOWN=ON.
2. Install any other accessories before completing the installation of the
processor.
3. Replace the cover (see page 24).
4. Turn on the computer and check that the new processor is recognized
by the power-on system-test.
52
Switch Switch Switch
3 4 5
UP DOWN UP
UP DOWN DOWN
DOWN UP UP
DOWN UP DOWN
DOWN DOWN UP
Bus Processor
Speed Speed
66 MHz 333 MHz
66 MHz 350 MHz
66 MHz 400 MHz
66 MHz 450 MHz
66 MHz 500 MHz
Chapter 2