If You Are Unable To Change Any Values In Setup; If A Post Error Message Is Displayed - HP PL Class 450/500/550/600/650/700/750 User Manual

Rebuild Your
Workstation's
Components
LCD Error
Messages
Temp disk Check fans and that air flow
Temp CPU guide is not blocked.
Temp IO slot
Fan CPU Check that fans are installed
Fan disk correctly.
Fan IO slot
Power supply Check that power supply is
properly connected.
5. Replace the cover.
6. Reconnect all cables and power cords.
7. Turn on the display and computer.
If your Workstation still does not start properly, remove all boards and
accessories, except the hard disk drive and video board. Start the
Workstation. If the Workstation now works, add the boards and
accessories one at a time to determine which one is causing the problem.

If you are Unable to Change any Values in Setup

Ensure that you are using the correct password.

If a POST Error Message is Displayed

The Power-On-System-Test (POST) can detect both an error and a
change to the configuration. In either case, an error code and short
description is displayed. Depending on the kind of error, you will have
one or more of these choices available on screen:
Chapter 3
Troubleshooting Your HP Visualize Linux Workstation
If Your Workstation Does Not Start Properly
Action Reference
Refer to the section "Moving the
Power Supply" in the chapter
"How to Install Accessories
Inside Your HP V
ISUALIZE
Workstation."
Refer to the section "Moving the
Power Supply" in the chapter
"How to Install Accessories
Inside Your HP V
ISUALIZE
Workstation."
Refer to the side heading
"Replacing the Power Supply
after Installing Accessories" in
the chapter "How to Install
Accessories Inside Your HP
V Linux Workstation."
ISUALIZE
Linux
Linux
59