Installing Accessory Boards; Installing The Board - HP PL Class 450/500/550/600/650/700/750 User Manual

CAUTION
NOTE
How to Install Accessories In Your HP Visualize Linux Workstation

Installing Accessory Boards

Static electricity can damage electronic components. Turn OFF all
equipment. Don't let your clothes touch the accessory. To equalize the
static electricity, rest the accessory bag on top of the computer while you
are removing the accessory from the bag. Handle the accessory as little
as possible and with care.
The Workstation has the following accessory board slots:
• Slot AT 2 (the bottom slot) for full-length 16-bit ISA boards
• Slot AT 1/PCI 4 for either a 16-bit ISA board or a full-length 32-bit
PCI board
• Slot PCI 3 for a full-length 32-bit PCI board
• Slot PCI 2 for a full-length 32-bit PCI board
• Slot PCI 1 for a full-length 32-bit PCI board
• Slot AGP for the video adapter board

Installing the Board

1. Disconnect the computer's power cord and any LAN connection or
telecommunications cable.
PCI boards are configured automatically when installed in the
Workstation.
2. Remove the computer's cover (see the section "Removing and
Replacing the Cover") and carefully place the Workstation on its side.
3. Find an empty slot. You should refer to the section "System Board
Switches" in the chapter "Technical Information" to identify the
location of the slot type you want to use (ISA or PCI).
Some boards may have preferred locations and special installation
Chapter 2
Installing Accessory Boards
47