Other Features - HP PL Class 450/500/550/600/650/700/750 User Manual

POST Phase
Troubleshooting Your HP Visualize Linux Workstation
Using HP MaxiLife to Diagnose Problems
Following these checks, the POST (Power-On Self Test) sequence is
initiated. One of the following screens will appear in this phase:
HP KAYAK XA-s
No errors occurred.

Other Features

HP MaxiLife can also be configured to:
• Display the configuration details of your Workstation required to
obtain support (System info.)
• Indicate POST (Power-On Self Test) steps during the power-on
phase (Boot steps)
• Perform diagnostic tests on your Workstation's various hardware
components and display the results (Diags).
To configure your HP LCD:
1. Ensure that your Workstation's power cord is connected to a
grounded outlet.
In this state, your Workstation's hardware management chip is
active, even if your system is not powered on.
2. Press one of the LCD control buttons. The following menu is
displayed.
System info
Boot steps
Next
3. Use to scroll down through the menu items and
required menu item.
72
Error!
POST XXXX
A POST error occurred. Refer
to the section "If a POST Error
Message is Displayed" for
more information.
Go
Diags
Exit
Next Go
to select the
Chapter 3