Internal Mass
Storage Devices
Pack of five pairs of rails for
Front Access Devices:
- 3.5-inch disk drives
- 5.25-inch disk drives
Up to six accessory boards
can be installed:
- One AGP slot (graphics)
- Three 32-bit PCI slots (one used by SCSI/LAN board)
- One combination PCI or ISA slot
- One 16-bit ISA slot
IMPORTANT
How to Install Accessories In Your HP Visualize Linux Workstation
Supported HP Accessories
This chapter describes how to install memory, mass storage devices, and
accessory boards in your computer.
Some of the accessories mentioned in this section reflect components that
were not fully qualified with the Linux Operating System by HP at the
time this manual was written. However, they are stated as being
supported by Red Hat Version 6.0.
Contact HP or your dealer for an up-to-date list of supported devices.
Chapter 2
Supported HP Accessories
Main Memory Upgrades
DIMM slots for 100 MHz SDRAM:
- 128 MB
- 256 MB
Front Access Drives, for example:
- 3.5-inch 1.44 MB flexible disk drive
(one third height)
- 5.25-inch DDS tape drive (half heigh
21