Using Timing Commander To Program The Devices; Output Clock Monitoring/Measurement - Renesas CLK-104a Manual

CLK-104a/b Boards Using Renesas RF-PLL and RF-Synthesizer Solutions Manual

5. Using Timing Commander to Program the Devices

For ease of use, Renesas' free-of-charge software tool – Timing Commander is recommended to configure and
program the CLK-104 board/devices (8V19N491-24, 8V19N882, and 8V97003). If you have any questions on
the Timing Commander software download or TCP/TCS files, please contact
sync@lm.renesas.com.
In the Timing Commander GUI, when the settings file (.tcs) is loaded:
1. Click on the button in the upper-right corner to display the Connection Settings window.
2. Select USB/SPI in the Connection Settings window.
3. Click the chip symbol button in the upper-right corner of the GUI to initiate the connection to the targeted
device.

6. Output Clock Monitoring/Measurement

The following SMA connector pairs are available to monitor/measure the output frequencies from devices on the
CLK-104 board:
■
J15/J16 – 8V97001 #1 Output A
■
J14/J17 – 8V97001 #1 Output B
■ J19/J20 – 8V97001 #2 Output A
■
J18/J21 – 8V97001 #2 Output B
■
J12/J13 – 8V19N491-24 Output QREF_A2/nQREF_A2
Other outputs are connected to the connector, and therefore, are not accessible.
R31UH0011EU0100 Rev.1.00
Nov 26, 2021
Figure 6. Connection Setting window to select SPI mode
IDT-Support-
Page 5