Specifications; Packaging; Installation; Unpacking The Centrifuge - Labnet Spectrafuge 16M Instruction Manual

4 .0 Specifications

Dimensions (W × D × H)
Maximum speed
Maximum RCF
Maximum volume
Admiss. density
Electrical/fuse rating
C0160
C0160-230V
Operation conditions
The Labnet Spectrafuge 16M Microcentrifuge is designed to be safe at least when operated under the following conditions:
Indoor use only

Altitude up to 2,000 meters

Pollution degree 2


5.0 Packaging

Description
Labnet Spectrafuge™ 16M microcentrifuge
Instruction manual
Power cord
C0160 (NA plug)
C0160-230V (EU and UK plugs)
Rotor screw wrench and screw

6.0 Installation

6.1 Unpacking the centrifuge

Before unpacking the centrifuge, inspect the outside of the carton for any shipping damage. The centrifuge is delivered in a carton
with protective cushions. Remove the centrifuge from the carton. Retain the carton and cushions until it has been established that the
centrifuge is working properly. Inspect the centrifuge for any visible signs of shipping damage. Shipping damage is the responsibility
of the transportation carrier. Any claims for damage must be filed within 48 hours. The accessories supplied with the centrifuge
should be kept with the instruction manual near the centrifuge's place of installation.

6.2 Required space

The centrifuge should be installed on a rigid, even surface such as a stable laboratory bench, cabinet, etc. To guarantee sufficient
ventilation, ensure that the centrifuge has at least 15 cm (6 inches) of free space on all sides, including the rear. The centrifuge should
not be located in areas subject to excessive heat such as in direct sunlight or near radiators or the exhaust of a compressor, as a
buildup of heat may occur within the chamber.
6.3 Installation
Make certain that the timer is set to the OFF position. Before operating the centrifuge, check that the power source corresponds to
that on the manufacturer's rating label, then connect the power cord to the centrifuge and the power source.
NOTE: The timer must be in the OFF position before connecting the power cord. Failing to place the timer in the OFF
position may result in damage to the centrifuge and injury to personnel.
2 | LABNET SPECTRAFUGE 16M MICROCENTRIFUGE
8.25 x 8.9 x 7.6 in. (21 × 22.6 × 19.3 cm)
14,000 rpm
16,000 x g
18 x 1.5/2.0 mL
1.2 kg/dm
3
120V ± 10%, 50/60 Hz, 1.3A/2.5AT
230V ± 10%, 50/60 Hz, 0.7A/1.25AT
5°C to 40°C, up to 80% RH, non-condensing
Qty
1
1
1
1
1