Inner Door Vent Cover - Haier GE DDT700S N0 Series Technical Service Manual

Inner Door Vent Cover

The inner door vent cover must be removed on
front control models (with passive vent) to allow
the front control console to be removed from
the inner door. Insert two pocket style flat-blade
screw-drivers into the vent, then turn counter-
clockwise to remove.
To Separate the Door:
1. Remove the door.
2. Place the door with the outer side on to a
protective surface.
3. Remove two 1/4-in. hex-head screws inside
the bottom of the door.
4. Remove four T-25 Torx screws (two each
side) that secure the inner door to the hinge
assemblies.
5. Slide the inner panel toward the top and the
outer panel to the bottom to disengage the
attachment strips. NOTE: The hinges are
secured to the outer door panel.
6. The attachment strips will disengage from the
outer panel.
7. Support the vent conduit while lifting the inner
door from the outer door panel.
– 31 –
(Continued next page)