Bottle Wash Components (Some Models)
To remove the bottle wash components, remove
the cover by releasing the clip at the bottom and
slide the cover to the right.
Disconnect the hose.
Slide the bottle wash manifold to the front (right)
of the rack.
To remove the mid conduit, push on the tab and
slide the conduit to the back of the rack.
Lower Rack
Several lower racks are available with different
tine configurations; consult the Owner's Manual
for details on the lower racks.
The lower rack roller assemblies consist of
brackets, rollers, and covers (left or right, two per
side) as well as rollers (four per side).
To remove the lower rack rollers, lift up on the
cover (shaded grey in the image below) to
release; then pull out on the cover to unclip the
center tabs.
The rollers will slide off the bracket and the
bracket (shaded grey in the image below) is
pushed to the rear of the rack to remove.
– 26 –
Bracket
Rollers
Cover
Tabs in center
(Continued next page)
Need help?
Do you have a question about the GE DDT700S N0 Series and is the answer not in the manual?
Questions and answers