Inner Door Vent Cover - Haier GE CDT800P2N3S1 Technical Service Manual

https://appliancetechmanuals.com

Inner Door Vent Cover

The inner door vent cover must be removed on
front control models (with passive vent) to allow
the front control console to be removed from
the inner door. Insert two pocket-style flat-blade
screw-drivers into the vent, then turn counter-
clockwise (CCW) to remove.
To Separate the Door
1. Remove the door.
2. Place the door with the outer side on to a
protective surface.
Protective Surface
3. Remove two 1/4-in. hex-head screws inside
the bottom of the door.
4. Remove four T-25 Torx-head screws (two
each side) that secure the inner door to the
hinge assemblies.
5. Slide the inner panel toward the top and the
outer panel to the bottom to disengage the
attachment strips. NOTE: The hinges are
secured to the outer door panel.
6. The attachment strips will disengage from the
outer panel.
7. Support the vent conduit while lifting the inner
door from the outer door panel.
– 31 –
(Continued next page)