Haier GE DDT700S N0 Series Technical Service Manual page 30

8. Slide the cable into the cable clip to prevent
the spring from disconnecting from the cable.
CAUTION: If the cable is released, the spring and
cable may become disconnected. Depending
on the model and installation, reconnecting may
require the dishwasher to be removed from
installation.
The cable seated correctly into the clip is shown
below.
9. Repeat steps 5 through 8 on the opposite
side.
10. Standing in front of the dishwasher, open the
door a few inches, then lift the door and hinge
arms off of the offset leg.
When installing the door onto the dishwasher,
make sure the hinge pins located on the hinge
arms are placed fully on the offset legs (both
sides).
– 30 –