Haier DW12-LBE Instructions For Use Manual

Haier dishwasher instructions for use
Hide thumbs

Advertisement

Quick Links

Dishwasher
DW12-LBE
Instructions for Use
en

Advertisement

loading

  Related Manuals for Haier DW12-LBE

  Summary of Contents for Haier DW12-LBE

  • Page 1 Dishwasher DW12-LBE Instructions for Use...
  • Page 2: Close-Up View (Control Panel)

    - After removing the packing, check to make sure that the appli- ance is not damaged. If in doubt, contact a qualified professional. - The dishwasher must only be used by adults for the washing of household dishes and cooking utensils.
  • Page 3: Close-Up View (Interior)

    Close-up View (Interior) Upper Rack Rack Height Adjustor Top Spray Arm Lower Rack Bottom Spray Arm Specifications Width Depth Height Capacity Mains Water Pressure Power Voltage Total Absorber Power Washing Filter Detergent and Rinse Aid Dispenser Salt Container Cap Third Sprayer 12 standard place settings 60cm 58cm...
  • Page 4 S a l t Salt The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water.
  • Page 5: Detergent And Rinse Aid

    Detergent and Rinse Aid Detergent Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle Table." The detergent dispenser is located on the inside panel of the door.
  • Page 6: Loading The Dishwasher

    Loading the Dishwasher Before placing the dishes in the dishwasher, remove larger food particles to prevent the filter from becoming clogged, which re- sults in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they are soaked before washed.
  • Page 7: Starting The Appliance

    "Setting and starting a wash cycle". Wash Cycle Program Light The dishwasher is equipped with a LCD indicator light (G) that turns on when the appliance is running the wash cycle. At the end of the wash cycle Six beeps will indicate that the wash cycle has finished and the LCD display (B) will come on (see fig.1).
  • Page 8: Energy Saving Tips

    Energy Saving Tips It is important to try and run the dishwasher when it is fully loaded in order to save on energy. To prevent odours from form- ing and food from caking onto the dishes, you can run the soak cycle.
  • Page 9: Wash Cycle Table

    Wash Cycle Table Cycle Extra drying Very dirty dishes, pots and pans. (not to be used with deli- cate items) Heavy Duty Normal dirty dishes, pots and pans. standard daily cycle. Normal Wash Light Wash (IEC-EN50242) Glass ware Rapid Wash Rinse Soak Cycle Selection Information...
  • Page 10: Troubleshooting

    Troubleshooting It may occur that the dishwasher does not function or does not function properly. Before calling for assistance, See what can be done first: have you forgotten to press one of the buttons or...
  • Page 11: Installation

    Levelling the Appliance Once the appliance is positioned, adjust the feet (screwing them in or out) of the dishwasher until it is level. In any case, the appliance should not be inclined more than 2 . If the appliance is level, it will help ensure proper performance.
  • Page 12 Installation Diagram A.Wiring box B.Door switch F.Half wash switch G.Softer valve J.Washing motor K.Temperature limiter O.Salt missing switch CnL1 CnP3 CnP2 SCHEDA DI POTENZA CnP1 CONTROLLO RELE' C.Water level switch H.Dispenser valve L.Heater P.Rinseing aid missing switch IAQS D-ED D.Drain motor E.Overflow switch I.Aquastop inlet valve M.Relay...