HP VISUALIZE fx6 Configuration and Troubleshooting Guide
If you require any help to configure and use the OpenGL video driver, or you
have some hardware or software problems, refer to the HP VISUALIZE fx6
Configuration and Troubleshooting Guide on the HP World Wide Web site:
This guide can also be found on the Kayak Drivers CD-ROM (delivered with
the PC Workstation).
HP VISUALIZE fx6 Diagnostics Utility
A diagnostics utility for the HP VISUALIZE fx6 video controller is
preinstalled on the hard disk. To run this utility,
Start/Programs/HP Diagnostics/HP Visualize Diagnostics
The diagnostic utility can also be found on the Kayak Drivers CD-ROM
(delivered with the PC Workstation) or on the HP World Wide Web site
(refer to above for the WWW address).
This utility can be used only when Windows NT in VGA mode is running and
the HP VISUALIZE fx6 OpenGL driver is installed. It provides a good level of
confidence in the video hardware in situations such as intermittent system
hangs or unusual graphics behavior on the screen.
If you are not in Windows NT VGA mode, reboot the PC workstation,
selecting Windows NT VGA mode when prompted during the startup