HP Kayak PC Workstation Overview
The following table provides an overview of the HP Kayak XW Series 0480
PC Workstation. Features that are specific to this PC Workstation (and not
found on the HP Kayak XU 0441 model) are highlighted by underlining.
Component
All models have: Intel Pentium
Microprocessor
memory. Support for up to two Pentium II Xeon processors.
450 MHz: 100 MHz FSB.
External
Processor Bus
(Front Side Bus)
Runs at the same speed as the Processor.
Level 2 Cache
Bus
All models are preloaded with Windows NT® 4.0.
Operating
System
Note: Registered ECC SDRAM memory modules cannot be mixed with Unbuffered
modules.
Main Memory
Four DIMM sockets supporting:
512 MB Registered 100 MHz ECC SDRAM memory modules to a maximum of 2 GB, or
64 MB, 128 MB or 256 MB unbuffered 100 MHz ECC SDRAM to a maximum of 1 GB.
All models have seven shelves:
five front-access (two 3½-inch, three 5¼-inch); two internal (3½-inch).
Mass Storage
4.5 GB or 9.1 GB Ultra-Wide SCSI Low Profile (LP)
Optional HP FastRAID 2
Ultra-Wide 16-bit internal SCSI connector for both external and internal drives (up to
SCSI
40 MB per second), plus two internal narrow SCSI connectors.
Connectors
Subsystem with HP FastRAID Port.
Equipped with an
Video
SGRAM video memory. The
Controllers
SDRAM texture memory. The HP VISUALIZE fx6 has two connectors on the board, one
for the AGP slot and the other for the PCI slot.
Features
®
II Xeon™ processors with 512 KB or 1 MB cache
nd
generation
HP VISUALIZE fx6 AGP
video board. There is 18 MB of installed
Texture module upgrade
HP Kayak PC Workstation Overview
supplies 32 MB of additional
5
Need help?
Do you have a question about the Kayak XW04 and is the answer not in the manual?